I CDMSC ™ — Can type double end integral static ring compensation type convection seal

The integral design of the seal ring improves the stability of the seal ring under high-temperature and high-pressure conditions,

Prolong the service life of the seal in such working conditions

The driving contact area of the sealing ring is large, so as to prevent the equipment from starting or stopping under viscous liquid conditions

Damage to sealing ring

The internal clearance is large, which maximizes the cooling/heat dissipation effect of the seal and extends the service life of the seal. Compared with other competitors, the seal can withstand greater radial runout

Provide built-in cooling and heat dissipation sleeves to improve the sealing environment and extend the service life of seals

Sizes range from 1.250 "to 8.000" (30mm - 200mm)

CSWIB ™ (Mixmaster I ™) DSWIB ™ (Mixmaster II ™)

2、 CSWIB Single end cartridge seal with built-in bearing DSWIB Double end cartridge seal with built-in bearing

Designed for agitators and mixers

Built in bearings are installed to stabilize the shaft and seal ring

With long cantilever shaft, it is an ideal choice for mixers

It is equipped with water inlet and drain holes to provide cooling or heat dissipation to extend the sealing

Service life in poor condition

III Mixmaster IV ™ — Cartridge seal series for mixer

With long cantilever shaft, suitable for mixers and mixers with top entry

You can choose with or without load bearing. Bearing conforms to DIN28-138 No. 1

Part 2 Requirements.

The hydraulic reverse balance design reduces the load on the sealing face and extends the

Service life and enable the seal to work in a vacuum environment

No wear design of shaft, reducing the maintenance cost of equipment

There are many flanges to choose from

Sizes range from 1.000 "to 10.250" (24mm - 260mm)